SEAGATE TECHNOLOGY, INC. Customer Technical Support FAX Network +1 408 438-8137 Customer Technical Support Bulletin Boards (300-9600, 8-N-1) ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ United States +1 408 438-8771 ³ United Kingdom +44 628 478011 ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ´ ³ Germany +49 89 140-9331 ³ Singapore +65 227-2217 ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ (C)opyright 1993 ST-3390N Rear View ÚÄ 50 pin SCSI Interface I/O connector ³ ³ DC power (TOP) ÕÍÍÍÍÍÍÍÍÍÍÍÍ ÍÍÍÍÍÍÍÍÍÍ͸ /Ä5ÄGÄGÄ12\ ÍÍÍ͵::::::::::::::::::::::::1Æ͵ 0 0 0 0 ÆÍ (BOTTOM) ÔÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ; ÀÄÄÄÄÄÄÄÄÄÙ ÚÄÄÄÄÄ1 ÚÄÄÄÄÄ1 ÚÄÄÄÄÄ1 ÀÄÄÄÄÄÙ ÀÄÄÄÄÄÙ ÀÄÄÄÄÄÙ Terminating Resistor Packs ST-3390N Left View o o o1 (TOP) o o o Õ͸ Front....ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍØÍØÍØÍÍÍÍ͵ I/O connector ³ ³ ³ Ô; SCSI Address ID 1 ÄÙ ³ ³ ID 2 ÄÄÄÙ ³ ID 4 ÄÄÄÄÄÙ ST-3390N Right View o o4 o o o6 (TOP) Õ͸ 1o³o 1o³o o DC Power ÆÍÍÍÍØÍÍÍÍÍÍ ³ ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ Ô; ³ ³ ³ ÄÄÁÄÄÄÄ ³ Active/Passive Termination ÄÄÁÄÄ ÄÄÂÄÄÄÄ Terminator Power ÚÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ÄÄÂÄÄ ³ Active: Pins 1 & 2 shorted ³ ³ ³ only (+2.85V to ³ ³ ³ 110 ê) for FAST ³ ³ ³ SCSI; ³ ³ ³Passive: Pins 2 & 4 shorted ³ ³ ³ AND pins 5 & 6 shorted ³ ³ ³ (+5V and GND to ³ ³ ³ 220/330 ê) for ³ ³ ³ standard SCSI. ³ ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ ³ ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³Terminator Power: From SCSI Connector ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ Pins 1 & 2 ³ ³ From Power Connector ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ Pins 1 & 3 ³ ³ To SCSI Connector Only ÄÄÄÄÄÄÄÄÄÄÄÄÄ Pins 3 & 4 ³ ³ From Power Connector and ÄÄÄÄÄÄÄÄÄÄÄ Pins 1 & 2 AND ³ ³ to SCSI Bus --------------------------- 3 & 4 ³ ³ Terminating Resistors not Installed Ä Pins 2 & 4 ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ ST-3390N Front View ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ SCSI ID's (none for ID0) ³ not used if ID set on side jumpers ³ ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄ Ext. Spindle Clock Synch ³ ³ pin-5 is Clock Ground ³ ³ ÚÄÄÄÄÄÄÄÄÄÄÄÄ Remote LED (TOP) ÚÄÁÄ¿ ³ ³ ÚÄÄÄÄÄÄ Reserved 4 2 1 ³ ³ ÚÄÄÄÁÄÄÄ¿ o o o o o-o o o o o 1o o o o o+o o o o o o o o o+ ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ1o o o o-ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ ³ ³ ³ ³ (BOTTOM) ³ ³ ³ ÀÄÄ Remote LED ³ ³ ÀÄÄÄÄ Ext. Spindle Clock Synch ³ ³ pin-5 is Clock Ground ³ ÀÄÄÄÄÄÄ Remote Start Enable ÀÄÄÄÄÄÄÄÄ Parity Enable ST-3390N UNFORMATTED CAPACITY _____________________ FORMATTED CAPACITY (xx SECTORS) __________344.3 AVERAGE SECTORS PER TRACK ________________83 rounded down ACTUATOR TYPE ____________________________ROTARY VOICE COIL TRACKS ___________________________________8,028 CYLINDERS ________________________________2,676 (user) HEADS ____________________________________3 DISCS (3.5 in) ___________________________2 MEDIA TYPE _______________________________THIN FILM HEAD TYPE ________________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (1,7) INTERNAL TRANSFER RATE (mbits/sec) _______21.6 to 36.3 EXTERNAL TRANSFER RATE (mbyte/sec) _______4 Async EXTERNAL TRANSFER RATE (mbyte/sec) _______10 Sync SPINDLE SPEED (RPM) ______________________4,500 AVERAGE LATENCY (mSEC) ___________________6.67 BUFFER ___________________________________256 Kbyte SeaCache Multisegmented, read look-ahead INTERFACE ________________________________SCSI-2 Fast BYTES PER TRACK __________________________42,888 avg. SECTORS PER DRIVE ________________________672,480 TPI (TRACKS PER INCH) ____________________3,000 BPI (BITS PER INCH) ______________________52,602 AVERAGE ACCESS (ms) ______________________12 SINGLE TRACK SEEK (ms) ___________________<4 MAX FULL SEEK (ms) _______________________30 MTBF (power-on hours) Office _____________250,000 POWER REQUIREMENTS: +12V START-UP (amps) _1.9 POWER MANAGEMENT (Watts): ACTIVE _______________5.75 IDLE _________________3.0 WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl) _______________________AUTO IBM AT DRIVE TYPE ________________________0 Formatted at the factory with 2 alternate cylinders. Total physical cylinders equal 2678. Physical: Height (inches/mm): 1.00/25.4 Width (inches/mm): 4.02/102.1 Depth (inches/mm): 5.77/146.6 Weight (lbs/kg): 1.5/0.68 Note: If FAST SCSI transfer rates are used, then the active termination options must be used. If the transfer rates are 5.0 MBytes/sec and below, either method of termination can be used. Although active and passive terminated devices can be installed on the same bus, both ends of the cable should be terminated in the same manner, either both active or both passive. Note: If your application requires no terminators, remove the terminators from the circuit board. Merely removing the terminator power source selection jumper does not disconnect the terminator resistors from the circuit. ZBR = Zone Bit Recording = Variable sectors per track Seagate reserves the right to change, without notice, product offerings or specifications. (08/08/94)