SEAGATE TECHNOLOGY, INC. Customer Technical Support FAX Network +1 408 438-8137 Customer Technical Support Bulletin Boards (300-9600, 8-N-1) ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ United States +1 408 438-8771 ³ United Kingdom +44 628 478011 ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ´ ³ Germany +49 89 140-9331 ³ Singapore +65 227-2217 ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ (C)opyright 1994 ST-3295A (Medalist 270xe) TOP 4-pin DC Power ÕÍÍÍÍÍÍÍÍÍÍ ÍÍÍÍÍÍÍÍ͸/Ä4Ä3Ä2Ä1Ä\ ÍÍÍÍÍÍÍÍÍ͵::::::::::ù::::::::1Ƴ 0 0 0 0 ÆÍ ÔÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍÍ;ÀÄ5ÄGÄGÄ12Ù (pin-20 missing for keying purposes) (Options jumper located on bottom) (back of drive) Master OFF, Slave ON ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ 8o-o7 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄ 0 0 1 Slave Present ON (standard) ÄÄÄÄÄÄÄÄÄ o-o ÄÄÄÄÄÄÄÄÄÄÄÄÄÄ 0 1 0 ÚÄÄÄ - - - o-o ³ ³ ³ Cable Select ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ ÚÄ Ä Ä Ä 2o-o1 S M S Slave Present ON for ÄÄÄÄÄÄÄÄÙ (front of drive) i a l drives that don't have n s a the -DASP signal (use g t v only ONE of the Slave l e e Preset choices) e r Spare jumper stored on pins 1-3 ST-3295A Medalist 270xe FORMATTED CAPACITY (xx SECTORS) __________272.7 ACTUATOR TYPE ____________________________VOICE COIL TRACKS ___________________________________ CYLINDERS ________________________________(user) HEADS _(PHYSICAL)_________________________2 DISCS (3.5 in) ___________________________1 MEDIA TYPE _______________________________THIN FILM HEAD TYPE ________________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (1,7) INTERNAL TRANSFER RATE (mbits/sec) _______19.5 to 35.8 EXTERNAL TRANSFER RATE (mbytes/sec) ______11.1 SPINDLE SPEED (RPM) ______________________3,811 AVERAGE LATENCY (mSEC) ___________________7.87 BUFFER ___________________________________120 Kbyte Multisegmented, SeaCache INTERFACE ________________________________AT SECTORS PER DRIVE ________________________532,700 TPI (TRACKS PER INCH) ____________________3,285 BPI (BITS PER INCH) ______________________61,700 FCI (FLUX CHANGES PER INCH) ______________46,390 AVERAGE ACCESS (ms) ______________________14 SINGLE TRACK SEEK (ms) ___________________5 MAX FULL SEEK (ms) _______________________34 MTBF (power-on hours) Office _____________300,000 ACOUSTICS (typ/max dBA) __________________29/33 SHOCK (Normal/Abnormal/Nonoper.) _________2/10/75 POWER REQUIREMENTS: +12V START-UP (amps) _1.1 +5V START-UP (amps) _0.35 START-UP (watts)_8.5 POWER MANAGEMENT (Watts): ACTIVE _______________5.23 IDLE _________________1.865 WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl) _______________________AUTO IBM AT DRIVE TYPE ________________________* Physical: Height (inches/mm): 1.00/25.4 Width (inches/mm): 4.02/102.1 Depth (inches/mm): 5.77/146.6 Weight (lbs/kg): 1.3/0.59 * MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE. (see below) Possible translation: 761 cyl, 14 heads, 50 sectors = 272,742,400 Note: A "custom" or "user-definded" CMOS drivetype may ask for a numerical value for the Write Precompensation cylinder and for the Landing Zone cylinder. A basic rule-of-thumb for drive models that do not require the old Write Precomp technique or a Landing Zone because they are Auto-Parking is to add 1 to the cylinder value being used. As an example: If cylinders equaled 820, then both Write Precomp and Landing Zone would be entered as 821. Some BIOS will convert this to 65535 or -1, which are functionally equivalent to "none (not used)". PHYSICAL/LOGICAL equivalent to NATIVE/TRANSLATION ZBR = Zone Bit Recording = Variable sectors per track Already low-level formatted at the factory. Since a User-definable or Custom translation geometry may be used, it is imperative that the values be written down and kept with your permanent records for retrieval in the event of CMOS battery failure. Seagate reserves the right to change, without notice, product offerings or specifications. (08/17/94)