SEAGATE TECHNOLOGY, INC. Customer Technical Support FAX Network +1 408 438-8137 Customer Technical Support Bulletin Boards (300-9600, 8-N-1) ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ United States +1 408 438-8771 ³ United Kingdom +44 628 478011 ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ´ ³ Germany +49 89 140-9331 ³ Singapore +65 227-2217 ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ (C)opyright 1993 ST-3195A 4-pin DC TOP Power ÕÍÍÍÍÍÍÍÍÍÍ ÍÍÍÍÍÍÍÍ͸/Ä4Ä3Ä2Ä1Ä\ ÍÍÍÍÍÍ͵::::::::::ù::::::::1Ƴ 0 0 0 0 ÆÍ ÔÍÍÍÍÍÍÍÍÍÍÑÍÍÍÍÍÍÍÍ;ÀÄ5ÄGÄGÄ12Ù (pin-20 missing for keying purposes) (back of drive) 2o-o1 ÄÄÄÄÄÄÄÄ¿ o-o ÄÄÄÄÄÄ¿ ³ o-o ÄÄÄÄ¿ ³ ³ (Options jumper located on bottom) 8o-o7 ÄÄ¿ ³ ³ ³ (front of drive) ³ ³ ³ ³ ³ ³ ³ ÀÄÄ Master OFF, Slave ON ÄÄÄÄÄ 0 0 1 ³ ³ ÀÄÄÄÄ Slave Present ON ÄÄÄÄÄÄÄÄÄ 0 1 0 ³ ÀÄÄÄÄÄÄ Factory Test ³ ³ ³ ³ (do not use) S M S ÀÄÄÄÄÄÄÄÄ Reserved i a l n s a g t v l e e e r ST-3195A UNFORMATTED CAPACITY _____________________ FORMATTED CAPACITY (xx SECTORS) __________170.7 AVERAGE SECTORS PER TRACK ________________ rounded down ACTUATOR TYPE ____________________________VOICE COIL TRACKS ___________________________________ CYLINDERS ________________________________(user) HEADS _(PHYSICAL)_________________________4 DISCS (3.5 in) ___________________________2 MEDIA TYPE _______________________________THIN FILM HEAD TYPE ________________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (1,7) INTERNAL TRANSFER RATE (mbits/sec) _______ to 21.1 SPINDLE SPEED (RPM) ______________________3,811 AVERAGE LATENCY (mSEC) ___________________7.87 BUFFER ___________________________________64 Kbyte Multisegmented INTERFACE ________________________________AT SECTORS PER DRIVE ________________________333,540 TPI (TRACKS PER INCH) ____________________2,178 BPI (BITS PER INCH) ______________________38,400 AREAL DENSITY (MBits/sq in) ______________ AVERAGE ACCESS (ms) ______________________16 SINGLE TRACK SEEK (ms) ___________________5 MAX FULL SEEK (ms) _______________________32 MTBF (power-on hours) Office _____________250,000 POWER REQUIREMENTS: +12V START-UP (amps) _1.0 POWER MANAGEMENT (Watts): ACTIVE _______________4.6 IDLE _________________3.9 WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl) _______________________AUTO IBM AT DRIVE TYPE ________________________* Physical: Height (inches/mm): 1.00/25.4 Width (inches/mm): 4.02/102.1 Depth (inches/mm): 5.77/146.6 Weight (lbs/kg): 1.5/0.68 * MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE. (see below) Possible translation: 981 cyl, 10 heads, 34 sectors = 170,772,480 Note: A "custom" or "user-definded" CMOS drivetype may ask for a numerical value for the Write Precompensation cylinder and for the Landing Zone cylinder. A basic rule-of-thumb for drive models that do not require the old Write Precomp technique or a Landing Zone because they are Auto-Parking is to add 1 to the cylinder value being used. As an example: If cylinders equaled 820, then both Write Precomp and Landing Zone would be entered as 821. Some BIOS will convert this to 65535 or -1, which are functionally equivalent to "none (not used)". PHYSICAL/LOGICAL equivalent to NATIVE/TRANSLATION ZBR = Zone Bit Recording = Variable sectors per track Already low-level formatted at the factory. Since a User-definable or Custom translation geometry may be used, it is imperative that the values be written down and kept with your permanent records for retrieval in the event of CMOS battery failure. Seagate reserves the right to change, without notice, product offerings or specifications. (06/22/93)